![]() Just to be sure, I disconnected todays additions and checked my wiring, all OK. (the manual is about as much use as a handbrake on a canoe) Thanks P.S. Any ideas how the get the alram back to default state. I can't get the keypad to light up, and the PIRs are not flashing. Now nothing is working (even after switching off the mains spur and disconnecting the battery) The Green panel LED is on, and the bellboxes both go ff for about 3 seconds on reconnect. I selected zone 00 (Alarm & Tamper circuits disabled)I then removed the Nexus panel cover & made the connections. I thought i'd be clever and rather than annoy the neighbours anymore than I already have with testing etc. In the manual (page 20) Menus 1-8 Programming Zones it shows a table of zones and the relevent info for each zone. Then today I've been busy installing door contacts and Garage PIR. ![]() Everything worked fine, walk tested, bellboxes & Quad PIRs. I've just spent the bank holiday weekend installing a Lynteck Nexus 8 Alarm.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |